Comparison Tool - Stamfag AG
gradient
Crown Die-Cutting-Tools

Tool Qualities

All stated quantities, in million labels per re-sharpening, are empirical values and can only be achieved with printed and coated wet glue label papers! The tool crowns are 20 to 25mm high and can be re-sharpened up to 20 times, without measurement changes!

 
Crown Die-Cutting-Tools

S5 Steel crown for up to 5 million labels
S10  High alloy steel crown for up to 10 million labels
STAMDUR   Tungsten carbide crown for up to 100 million labels

 
Full-Steel-Die Cutting-Tools

VS1 Solid steel Die for up to 5 million labels
VS10   
Solid steel Die           for up to 10 million labels
Stainless steel INOX    
Solid steel Die for special applications (e.g. Medical technology)
  • The above specified performances can only be achieved with professionally sharpened punching tools.
  • Tool crowns are dimensionally accurate replaceable and the aluminum base reusable! This saves significant costs!
  • Worn crown can be replaced by higher crown quality! This means; An S5 crown can be replaced with an S10 or even Stamdur crown.
  • Punching tools can be equipped with several height-adjustable slitter knives and additional slitter knife positions!
  • Equipped with an additional tool frame and tool plates, the tools can be used on all Die-cutting machines!

Tool Quality comparison diagram

Reduce cost, dramatically!

Find out in a simple way which punching tool quality is most cost-effective for your production by entering the number of labels numerically or moving the slider below the diagram.

This diagram allows you now to compare purchase-, change over-, sharpening- and crown replacement costs of the most commonly used high- and counter pressure dies of the Stamfag S5, S10 and Stamdur qualities.

Shipping costs for re-sharpening and any additional incurred in-house costs are not included in the diagram!

The cost comparison chart ranges up from 1- 600 (million labels). The reference punching knife has a circumference of 280mm and is equipped with two slitter knives, see picture.

The reference die used in computing this comparison is based on a circumference of 280mm and equipped with two waste slitters. The calculated data are empirical values based on experience with printed and varnished wet strength label paper.

To continuously improve our website and for technical reasons we use cookies. If you continue to visit this website, you agree to this. Privacy statement & Legal notice Accept